Resoldered pin 0 and now switch works fine. 73 and aloha, Den

Here you can have a look as well: https://github.com/oe1wkl/Morserino-32/blob/master/Hardware/Morserino-32_board_v3_schematics.pdf From Pin 0 to Ground.

Dennis, from "technical Overview" document: "A second push-button switch is connected to Pin 0 of the ESP32".

Worked perfectly. Re-soldered pin after touch test you recommended. Final question I promise. The push button switch does not work. Resoldered four pins on switch. Please give me the

Hi Tommy, Here is a link to the driver that Craig N1SFT had shared with us. https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers I also had to load the driver

Hello I have a problem at one of my friends alienware pc's. I cannot find the com port, so my question is what driver do he had to use to connect to his pc? Tommy

Here is a pin-out diagram of the Heltec module. Please check by directly touching the pin on the Heltec - it should trigger the left paddle. After that, check that there is actually good contact at

Using Curtis B. External keyer is perfect. Right Capacitive paddle sends dahs perfectly. Right side doesn't work. What solder connections should I check? Other thoughts? 73 Den

Found schematic for v3 but from the bottom I can't find pin 2 that runs to the left paddle. Need to check that solder connection and the corresponding ground. How can I fund the two pins? Tnx Den

Thanks, when I get mine I will contact you again. Get Outlook for iOS

Hi, Rich. As a matter of fact, there are at least two forks of Morserino that support straight keys. One is the project of Karetoth https://github.com/Karethoth/Morserino-32 and the other one is mine

It will. The first message by each subscriber is moderated… Willi

Hello Willi I have sent a test mail toio the sub groupe but it dont show up Tommy

I have set up a subgroup addon-pc-software for discussing these types of add ons that usually get some feed from teh serial output of the Morserino. If you arte interested in these things, you should

How to join that groupe? Tommy Den 13-02-2020 kl. 18:06 skrev Willi, OE1WKL:

I created a subgroup for all add-on software (usually running on a PC) for the Morserino-32. Please join that group if you are interested, and post there anything that relates to theses

Only ASCII text files are supported - so please do not try to upload a word processor file. But you can use Word to save a file as ASCII text! Willi Von meinem Mobiltelefon gesendet

Hi Rich, That is relatively easy! There is a “file upload” option that you can upload using WiFi. You may need to review the manual on how to get started with WiFi on the device: it’s a two step

Hi Is it possible to make and put in Morserino ,home made list and how to do ?, Like just a list of 3 letter words ,then four letter words ext , would Morserino Recognize Microsoft word ? , or is a

Would it be possible for someone to set up a subgroup on groups.io for the phrases trainer? There could be the MAIN group for the morserino and a EXTRAS subgroup for all other things. Although the