I tried my system again. The battery is big. Fully charged at 4.0v. If I switch the system on, I get random values from 2.8v, 3.2, 3.4, 3.3, 3.8, 3.1, 3.5...That is without paddle... 73 de Martial

Es sollte die (mit einem Voltmeter) gemessene Zellspannung eingestellt werden! Willi Von meinem Mobiltelefon gesendet

Hi, The new Heltec module i receive yesterday and build it in M32. Thank you very much Willi. The measurements are a little bit better than the old Heltec module but not accurate. Now on every start

Servus Willi, Was mir aufgefallen ist, ist ein antiproportionales Verhalten der Batteriekalibrierung. Ich habe eine 3,7 V LiPO Zelle mit 600 mAh in Betrieb. Stelle ich die niedrigste Zellspannung ein,

From the Readme on GitHub that describes the changes - there was a change in V 4.0: ### Changes V.4.0 #### General: * Support of new hardware (M32 2nd edition, on PCB board v 4, with Heltec WiFi

Hello group. Has the batter function changed? Press black button and power up? Should go into the battery set function, mine dosent? And when I switch on from a full charge I get an empty battery

Trimming AFTER soldering is perfectly OK and recommended. Before replacing a part, it would be wise to find out what the underlying problem is... Willi Von meinem Mobiltelefon gesendet

Willi, As I remember now, I may have trimmed the leads after soldering them. Was I not supposed to do that? If not, what are the specs on this particular trimmer, so I can order a replacement from a

Ian, can you pride us with pictures of the trimmer, both from above and from the soldering side? I am a bit confused by your remark that the pins of the trimmer are so short - they are not, as you can

Hi all. Any mechanical disease, are a surgical solution. Josep

Good evening, all. I built my Morserino-32 this past Friday night, and have been chasing one issue since then. Everything works perfectly. Except, I can barely hear the audio out the headphone jack. I

Just checking to see if anyone has any trouble-shooting suggestions for my Morserino's sound that has stopped working? On a volume scale of 1-10, I'm only able to get a 1 or a zero (i.e., low or off)

Bravo Thank you willi Ray Virus-free. www.avast.com -- Raymond Gilchrist: G0TUE https://www.facebook.com/g0tue/ https://www.instagram.com/g0tue/

You can change the parameter „Inter-word space“ to get more time to start your response! 73 Willi OE1WKL

The tubing is left over from a repair I did to an espresso machine. Surgical tubing would work as well. Here a a couple of pictures of the G4ZPY key I use. Rod KI7ZI Rod Proctor 864 Kalispell

Hi everyone, I just tried it with iOS 15.1 and yes, it works. 73, de Michael "Momo" DG9NDT Am Sa., 20.11.21 um 10:04 schrieb Willi, OE1WKL:

Yessssss Are mu solution with surgical drain tube !!! Enviado desde mi Galaxy -------- Mensaje original -------- De: "Rod Proctor via groups.io" <rlproctor@...> Fecha: 20/11/21 8:38 (GMT+01:00)

Yes, this should work. W

Yet another solution. Silicon tubing. Rod KI7ZI

Another question-is it possible to use an iPhone as a hotspot to connect the morserino online? Thanks. Dan Presley 503-701-3871 danpresley@me. com N7CQR@...